9920 v21.2.2.0 Configuration Guide Version 21.2.2.0.
>
Platform and Infrastructure Services
>
Running Configuration
> Reset Configuration
Published October 01, 2024
Search this document
Print this page
Email this page
View PDF
Previous
Next
Abstract
Preface
Text Conventions
Documentation and Training
Help and Support
Send Feedback
What's New in this Document
Introduction to the NPB Application
NPB Application Overview
Supported Device Information
Limitations
Network Traffic Monitoring
Access Control List
Create an IPv4 Access Control List
Create an IPv6 Access Control List
Create a MAC Access Control List
Encapsulation
Configure Encapsulation
Listener Policy
Configure a Listener Policy
Create a Listener Policy
Egress
Egress Policy
Create an Egress
Configure an Egress Policy
Egress-Group
Create an Egress Group
Route-Map
Create Egress Group
Create a Route-Map
Map ACLs with Route-Map
Interfaces
Create an Interface
IP Addresses
Configure an IP Address
MAC Address
Ingress
Ingress-Group
Create an Ingress Group
View Ingress-Group Details
Replication
Configure Replication
Header Modification
Header-Modification Flow
Tag-Stripping
802.1BR Tag-Stripping
Configure 802.1BR Tag-Stripping
VLAN Header Tag Stripping
Configure VLAN Tag Stripping
VN Tag Stripping
Configure VN-Tag Stripping
Tag Addition
Configure Tag Addition
Packet Truncation and Termination
Packet Truncation Flow
Configure Packet Truncation
Tunnel Termination Flow
Forward Incoming Traffic
Drop Incoming Traffic
Filter Message Header
Filter GTP-Tunneled HTTP Messages
Onboard Packet Capture
PCAP File Management
PCAP File Encoding
PCAP File Decoding
Configure Packet Capture
Configure Ingress and Egress ACL Capture
View Captured Packets
Tunnel Termination
Transport Tunnel Termination
Non-Transport Tunnel Termination
Outer VXLAN Header
Outer MPLS Header
Packet Mirroring
Enable Mirror Configuration
Terminate Transport Tunnels
Terminate Non-Transport Tunnels
View Transport Tunnel Statistics
Terminate and Scope-Shift Matrix
Link Aggregation
Static LAG
Configure Static LAG
Link Aggregation Control Protocol
Dynamic LAG
Configure Dynamic LAG
Load Balancing
Enable Load Balancing
Link Layer Discovery Protocol
Configure LLDP
Quality of Service
Configure a Quality of Service
Show and Clear QoS Counters
SNMP Monitoring
Supported SNMP Traps
Monitor Events with SNMP
Configure the SNMP Community String
Configure an SNMP-Trap Receiver IP Address
Configure SNMP V3 User
Platform and Infrastructure Services
Chassis Manager
Stratum
Line Card
Configure Line Card
Maximum Transmission Unit
Running Configuration
Apply Configuration
Reset Configuration
Managing Files
Enable USB Access
Port Management
Configure Breakout Mode
Port Creation
Network Time Protocol
Date and Time Settings
NTP Server
NTP Peer
Configure NTP
gRPC API Gateway
Logging
Event Logging
Forward Agent Logs
Reset Configuration
Before you begin
Before upgrading or downgrading the firmware, back up the running configuration.
Procedure
Save the default configuration to the running configuration to reset device configuration.
device# copy default-config running-config
